Author Topic: directional hitch for adjusting a lanyard?  (Read 1745 times)

jskeen

  • New Member
  • *
  • Posts: 1
directional hitch for adjusting a lanyard?
« on: April 04, 2011, 12:57:29 AM »
Gentlemen;  

I submit for your perusal, a bit of a conundrum I have run across and had no luck solving.  Hopefully the picture is relatively self explanatory, but I will try to clarify.  I need to be able to adjust the length of the wristband around my left wrist, and then release it one handed.  I know I could use something along the lines of a cl-194 cord lock, but that would have no class.  I'm sure there is some variation of a hitch out there that would do the same job, but look better and show off some advanced cordcraft much better.

Anyway, the cord is standard 7 cord 550 by Rothco, and the lanyard is a single piece running loop sinnet.  

Thanks for any ideas.

James

skyout

  • Sr. Member
  • *****
  • Posts: 436
    • Fancy Knots by skyout
Re: directional hitch for adjusting a lanyard?
« Reply #1 on: April 04, 2011, 02:14:32 AM »
Hi James and welcome to the forum.

Here's a simple Monkey Fist bracelet I tied for one of my daughters. Cross Lace cord with a 3/8" wooden core. It has an adjustable strap using a Fisherman's Knot (thanks to JD's "How to Make an Adjustable Switchback Strap by TIAT"
http://www.youtube.com/watch?v=5Z1k7ckqOI8

My 4 yr old granddaughter HAD to have one the same color as her Mom's too. lol She could remove it singlehandedly.


Sweeney

  • Global Moderator
  • Sr. Member
  • *****
  • Posts: 975
Re: directional hitch for adjusting a lanyard?
« Reply #2 on: April 04, 2011, 10:04:22 AM »
Hi James

As you have 2 cords running in parallel you probably need a separate knot to simulate the cord lock. A small turks head in thinner cord would do - draw it up fairly tightly and it will act as a sliding stopper (knot the cord ends to stop it coming off!).

Barry
« Last Edit: April 04, 2011, 05:28:46 PM by Sweeney »