International Guild of Knot Tyers Forum

General => Fancy and Decorative Knotwork => Fancy Knotwork Tutorials => Topic started by: asemery on October 27, 2016, 02:04:08 PM

Title: Spanish ring knot
Post by: asemery on October 27, 2016, 02:04:08 PM
spanish ring knot

(http://i.imgur.com/ooV7CPt.jpg)

(http://i.imgur.com/8g5DeLu.jpg)

(http://i.imgur.com/7My6e1T.jpg)


The spanish ring knot uses the 5 bight 3 lead TH knot as its base.
Sieze cord to mandrel and take working end around mandrel as shown.

(http://i.imgur.com/tPewj65.jpg)


Bring Working End over, under as shown.

(http://i.imgur.com/efhG8FN.jpg)


Place bottom bight over top bight.

(http://i.imgur.com/AMVmCLB.jpg)


WE (Working End) goes under over.

(http://i.imgur.com/xt9daPh.jpg)


Place bottom bight under top bight.

(http://i.imgur.com/Omm7hwy.jpg)


WE goes under, over.

(http://i.imgur.com/rdpEkNR.jpg)


Bring WE to left of standing end under, over.

(http://i.imgur.com/g2nAnTg.jpg)


Bring working end to right of standing under over.

(http://i.imgur.com/9ZWeEyn.jpg)


Bring WE to left of standing end under over.

(http://i.imgur.com/K2EFRbe.jpg)


Bring WE under two, over two.

(http://i.imgur.com/f8ZQF0G.jpg)


Bring WE under two, over two.

(http://i.imgur.com/dd3JlCJ.jpg)


Bring end under two, over two.

(http://i.imgur.com/zXMgyGD.jpg)


Bring WE under two and up through center of knot.

(http://i.imgur.com/5pRVx7r.jpg)


To make pendant tighten knot around coin or marble and cut the standing end (at 12 o'clock position) close to the knot,

(http://i.imgur.com/QvImJUU.jpg)


To make necklace pull standing back from under two (it is to the right of the WE emerging from center of knot)

(http://i.imgur.com/rG6t4dK.jpg)
Title: Re: Spanish ring knot
Post by: SS369 on October 27, 2016, 10:45:25 PM
Awesome, thank you Tony!

SS