International Guild of Knot Tyers Forum

General => Knot-related Computing => Topic started by: DerekSmith on November 10, 2018, 05:20:06 PM

Title: Skeleton
Post by: DerekSmith on November 10, 2018, 05:20:06 PM
Anyone have any idea what software would have been used to produce this image?

Found it on Facebook with no attribute.

Title: Re: Skeleton
Post by: SS369 on November 10, 2018, 11:40:55 PM
Wire frame graphics.
Many graphics software offer this.
Title: Re: Skeleton
Post by: KnotMe on November 11, 2018, 08:16:59 AM
Tie your knots with this stuff (https://www.beadfx.com/catalogue/nylon-mesh-tube-c-62_450/) (nylon mesh tubes), and you don't need a computer.   :D
Title: Re: Skeleton
Post by: DerekSmith on November 11, 2018, 09:15:32 AM
Thanks Carol,  that is what I call clever thinking.

Turns out that it is available over here in the UK as 'Hollow Craft Nylon Mesh Tubing', 30p per m.

I should have some here by next week to play with - I think the challenge though is going to be stopping my grandkids from making bracelets with it...  Perhaps I shouldn't have also ordered those magnetic endcaps.

Derek
Title: Re: Skeleton
Post by: struktor on November 11, 2018, 11:41:45 AM
Parameterization and Welding of a Knotbox.
Prof. Dr.-Ing. Daniel Loridick.
http://daniellordick.de/docs/Lordick-DMS-2011.pdf

(https://upload.wikimedia.org/wikipedia/commons/thumb/8/8b/Technische_Sammlungen_Dresden_-_Erlebnisland_Mathematik_-_Durchkrabbelknoten_-_DSC4404.jpg/640px-Technische_Sammlungen_Dresden_-_Erlebnisland_Mathematik_-_Durchkrabbelknoten_-_DSC4404.jpg)


https://youtu.be/mV6TS0axmpQ